DocuPen RC800 Bedienungsanleitung PDF herunterladen (Seite 14)

Points to Remember Before You Scan

What you scan is what you get. The DocuPen is sensitive to changes in direction and

scan speed and records every movement you make. The more uniform your scan swipe,

the better your scanned image results. This may take a little practice at first. Scanning

too quickly or abruptly changing acceleration causes the

RED X LED to flash, reminding

you to reduce your scanning speed. To obtain the best scan results, note the following:

The document you scan must be well supported on a smooth flat surface. It is recom-

mended that you hold the top of the document with one hand while you scan with the

other. Place the DocuPen just above the area you want to scan, with the LEDs on the

left side of the document to be scanned.

Detach the USB

cable while scan-

ning. It could hin-

der your gliding

motion by pulling

on one side of the

DocuPen.

Remove staples or clips as they will impede the glid-

ing movement and the resulted scan will be distorted.

Apply even pressure, in the center of the scanner to

allow the rollers to rotate smoothly.

Press the

Power ON button, select the desired color and resolution settings and slowly

glide the DocuPen down across the area you want to scan. The unit begins scanning as

soon as you start moving the pen. When you stop moving, the scan light (at the bottom

of the pen) shuts off and the DocuPen saves the data. You must wait momentarily till the

data is stored in memory. The DocuPen will then automatically shut off.

DocuPen Operation Manual 26

Hold document

Keep DocuPen flat

Do Not tilt

On-board memory and External memory card

DocuPen RC800 is equipped with 8MB on-board Flash-memory and a slot for external

Transflash memory card which gives you almost unlimited capacity.

The Transflash memory card slot is located on the right-hand side of the DocuPen

under the removable cover.

To remove the cover you have to place your index finger on the right side of the cover

(just above the USB port) and gently lift up.

The cover detaches and you see the Transflash

memory slot covered by the cradle.

Slide the cradle to the left and lift it up to open.

Place the Transflash card in the slot, press

lightly and close the cradle, sliding t to the right

until it clicks. Close the DocuPen cover.

DocuPen Operation Manual 27

Closed cover

Open Cover/

External memory slot

Open cradle

Transflash card inserted

1 2 ... 9 10 11 12 13 14 15

Kommentare zu diesen Handbüchern

Keine Kommentare

DocuPen RC800 Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern